When a compatible DJ controller is connected, you can switch to Internal Mode (INT) to control playback using on-screen controls instead of vinyl or CDJ platter control.

NOTE: Internal Mode is available only when a DJ controller with DVS support is connected to your device.

Switching to Internal Mode

Internal Mode is accessed via the Digital Vinyl System (DVS) settings. To enable Internal Mode, connect your compatible hardware and open Advanced Settings > Digital Vinyl System. Set the mode to Internal (INT).

Controls in Internal Mode

When Internal Mode is active with hardware connected, the following on-screen controls are available:

Nudge Controls — Use the nudge buttons to adjust playback position forward or backward. Nudging allows you to move the playhead without affecting the track's tempo.
 

Waveform Scrub — Tap and drag on the waveform display to move through the track. This is useful for cueing to a specific point before playing.
 

BPM Controls — When you switch the VOL / BPM button to BPM mode, you can see the tempo adjustment controls. However, when hardware is connected, tempo adjustments are typically controlled directly from your hardware's tempo slider rather than from the screen.
 

Tempo Adjustment via Hardware — Your connected controller's tempo slider continues to control the track's tempo in Internal Mode. This gives you the tactile control you're used to from your hardware setup.